Sale!

Topzone® 12 Pcs Bike Bicycle Cycling Tire Repair Patch Kit Tools Set

2 Round Patch (32mm Diameter) & 2 Square Patch (52x34mm) & 1 Large Square Patch (
1 Glue Tube (Vulcanization Rubber Cement)
1 Rasp Tool (Sanding Tool)

Instruction: 1. Get rid of the tire from the bike, by casting off the nuts. 2. Take out the flatted tube from the tire, the usage of the flat edges of Curved Lever Tools. 3. Once the tube is out, use a bike pump to fill the tube until it’s firm. Then, took for the leak within the tube, the usage of a bucket of water. Stay up for air bubbles at the same time as holding the inflated tube underwater. There could also be a couple of leak, so check all the tube. After locating the leak, Get rid of the tube from water, wipe it dry, mark the punctured spot with a chalk, and deflate air from the tube. 4. Scrape the damaged area of the tube with the Rasp tool, to scrub and roughen the outside for the patch. Rough surface would make sure that strong bond to the patch. The realm must be about the similar or reasonably larger than the patch that you simply about to use. 5. Apply one of the crucial adhesive, Glue tube, to the scraped area of the tube. Let the glue stand for 3-5 minutes, until it almost dry. 6. Make a choice a patch of appropriate size, Get rid of the protecting foil from the back and place the patch over the glued area. Press firmly to bond the patch in place. Ensure all edges of the patch are completely sealed. Let the patch dry for every other 20 minutes. 7. Check the entire tire once again (as described in step 3), to ensure the puncture was once securely sealed and no air is escaping. 8. In any case, sparsely place the tube back to the tire and inflate it. Install the tire back at the bike.
2 Round Patch (32mm Diameter) & 2 Square Patch (52x34mm) & 1 Large Square Patch (
1 Glue Tube (Vulcanization Rubber Cement)
1 Rasp Tool (Sanding Tool)
2 Rubber Tubes (for fixing non-US valves)
2 Curved Lever Tools & 1 Wrench